0 of 28 Questions completed
Questions:
You have already completed the quiz before. Hence you can not start it again.
Quiz is loading…
You must sign in or sign up to start the quiz.
You must first complete the following:
0 of 28 Questions answered correctly
Your time:
Time has elapsed
You have reached 0 of 0 point(s), (0)
Earned Point(s): 0 of 0, (0)
0 Essay(s) Pending (Possible Point(s): 0)
Dispose of broken or damaged tools even if they can be repaired.
Inspect tools frequently to make sure they are in good condition.
The term honeycomb refers to:
The term float refers to:
A ________ is used to rod concrete to a given grade.
A ________ is used on low-slump (1 inch or less) concrete to embed coarse aggregate just below surface of the concrete and to consolidate concrete.
A ________ is used to cut ________ partly through fresh concrete to act as controls to predetermine location of possible cracks and to improve appearance.
A ________ comes in various sizes and textures to produce a desired finish.
A ________ is used on large concrete surfaces to eliminate any high or low spots or ridges left after the rodding process.
Finishing is the process of working concrete to a desired texture.
A rod is a concave or radius at the bottom section of a curb, step, or base.
Identify the figure below:
Identify the figure below:
Identify the figure below:
Identify the figure below:
Identify the figure below:
Identify the figure below:
Identify the figure below:
Identify the figure below:
Identify the figure below:
Identify the figure below:
Patching is the process of filling form-tie holes, honeycombs, or any defects in the concrete.
The tool shown is a margin trowel.
Identify the tool below:
Identify the tool below:
Knee pads are used to disperse the weight of the cement mason on fresh concrete.
Sliders are stainless steel or fiberglass knee boards.
The figure below shows a flat file.